Tempo
TEMPO #
MM manual pp.1-55, 1-57
The tempo is global. A pattern does not store it, so changing the pattern never changes the tempo. A song row can carry a tempo of its own (see chapter 17, "Set a tempo for a row"). A row that has a tempo shows it as a number on its cell in the arrangement.
The Tempo field of the LCD shows the tempo in BPM with one decimal. It is on every workspace.
THE TEMPO SCREEN #
MM manual p.1-56
You set the tempo in the Tempo field itself, from 30 to 300 BPM, or in the TEMPO window that a click on the field opens.
- Drag the field up or down. Each pixel is half a BPM. Hold [⇧] to change it a tenth of a BPM at a time.
- Click the field and press [↑] or [↓] to change it by 1 BPM. Hold [⇧] for a tenth.
The decimal part is kept, so 120.5 is a tempo.
Click the field without dragging to open the TEMPO window, the machine's tempo screen:
- − and + change the tempo by 1 BPM, or a tenth with [⇧].
- TAP taps the tempo.
- NUDGE shifts the tempo for a moment, as [LEFT] and [RIGHT] on the machine. Press and hold −10 % or +10 %. The tempo is 10 % slower or faster while you hold it, and goes back when you let go. The keys [-] or [=] do the same while held.
- Change on release holds a dragged tempo back until you let go of the field, as [FUNCTION] held does on the machine. The field shows the new tempo while you drag and the machine takes it at the release.
- Sync INT and EXT choose the machine's own tempo or MIDI clock, as <TEMPO IN> in GLOBAL. Sync in GLOBAL opens the GLOBAL panel.
Press [Esc] or click outside the window to close it.
TAP TEMPO #
MM manual p.1-56
- Press [⇧] + [B] in time with the music. It works on every workspace.
- After the second tap the tempo is set and the page shows it, for example Tap tempo: 128.0 BPM.
The tempo is the average of the last five taps. A pause of two seconds starts the count again.
On workspaces other than Pattern, [B] taps too. On Pattern [B] is the Draw key of the piano roll.
EXTERNAL SYNCHRONISATION #
MM manual p.1-56
The machine runs on its own clock or follows a MIDI clock. The setting is in the GLOBAL panel.
- Click Global in the top bar.
- In the Sync card, click EXT beside Tempo in to follow a MIDI clock, or INT for the machine's own tempo.
- Click ON beside Ctrl in if the machine should also follow MIDI start and stop.
The Sync keys INT and EXT of the TEMPO window set Tempo in too.
In a DAW a new plug-in sets Tempo in to EXT and Ctrl in to ON itself, and the machine follows the host. Set Tempo in to INT to run the machine on its own clock in the DAW: the tempo edits again, and the DAW's tempo and transport no longer reach the machine. EXT follows the DAW again. The project keeps the choice. See chapter 19, "Control out 2" and "Control in", for the other settings of the card.